FFC/FPC Connectors

Results:

FFC/FPC connectors in this category are complete PCB-mounted assemblies that receive flat flexible cable or flexible printed circuit tails. Begin with the cable’s exposed conductor face, then match pitch, positions, mating thickness, entry direction and locking method before checking the PCB footprint.

Read the Mating Stack from Cable to Board

Actuator or Lock
FFC or FPC Tail
Exposed Conductor Surface
Connector Contact Beam
PCB Solder Joints and Hold-downs

A matching pitch does not guarantee a compatible connection. The cable conductors must face the connector’s contact beams, and the tail must fit within the specified mating-thickness range.

Match the Contact Face and Cable Entry

Top contact The exposed conductors face the upper contact area after the tail enters the connector.
Bottom contact The conductor surface faces the PCB side of the connector. Confirm the orientation from the series drawing.
Dual contact Contacts can engage either conductor orientation on supported designs, but tail thickness and layout still require verification.

Next, distinguish horizontal-entry connectors, where the tail approaches parallel to the PCB, from vertical-entry connectors, where it enters perpendicular to the board. If the required item is a separate housing, loose contact or accessory rather than a complete connector, return to FFC/FPC Connectors & Components to follow the appropriate product path.

Turn the Tail Drawing into Searchable Specifications

Pitch and positionsMatch the center-to-center conductor spacing and the number of conductive positions. Do not substitute the overall tail width for pitch.
Mating thicknessUse the finished thickness at the mating end, including any stiffener, rather than the nominal film thickness alone.
Exposed lengthConfirm that the exposed conductors reach the contact zone without placing the stiffener or insulation inside the electrical interface.
Pin-one orientationCompare the cable drawing, connector numbering and PCB footprint so the circuit order is not mirrored during assembly.

FFC and FPC describe different flexible interconnect constructions, but connector compatibility is established by the mating-tail dimensions and contact arrangement. For a broader comparison with board-to-board, wire-to-board and other PCB interfaces, see Printed Circuit Board Connectors Explained.

Fit the Lock into the Assembly Process

The locking mechanism affects insertion force, service access and the clearance required around the connector. ZIF and flip-lock designs allow the tail to enter before the actuator secures it; slider and back-lock mechanisms require access in a different direction. Non-ZIF versions rely on direct insertion and should be checked for the permitted mating cycles and insertion method.

  1. Confirm that the actuator can be opened after nearby components are installed.
  2. Check whether the cable can enter straight without twisting at the contact area.
  3. Compare the recommended PCB footprint, soldering method and hold-down arrangement.
  4. Use the selected series drawing to verify operating height and cable insertion depth.

Define the Insertion Envelope

Cable approach Actuator sweep Connector height First cable bend

Keep the first bend outside the connector’s mating and strain-sensitive area. Final clearances, bend limits and actuator operation must follow the drawing for the exact manufacturer series and part number.

Read More
FFC/FPC ConnectorsResults:
Comprehensive
Price Priority
Stock Priority
Image
Part Number
Description
Availability
Unit Price(USD)
Quantity
Operation
Available Stock
200
Estimated Ship Time:5-12 working days
10+$3.4845
50+$2.981
2,500+$1.7441
5,000+$1.7227
- +
Ext. Price(USD):$34.84
MOQ:10
Mult:1
SPQ:100
25 / PageGoto