Circular connectors provide detachable plug-and-receptacle interfaces for carrying signals, data or power through industrial equipment, panels and cable assemblies. Define the connector series and transmission task first, then match contact arrangement, coupling, coding, mounting, termination and environmental protection across both halves of the connection.
Define the Interface in Four Coordinates
Interface Family Identify the manufacturer series or standard, such as M8, M12, CPC or a MIL-spec interface.
Transmission Task Define whether the connector carries signals, industrial data, power or a hybrid combination.
Installation Point Choose a cable, panel, device or PCB interface and confirm the available mounting space.
Operating Environment Establish requirements for sealing, temperature, vibration, shielding and mating frequency.
Configure Both Halves of the Connection
Connector series → plug and receptacle → pin and socket contacts → matching arrangement and coding
Plug or receptacle describes the connector body and mating role, while pin or socket describes the contact interface. Confirm both dimensions instead of relying on a general male or female description. The two halves must share a compatible series, shell size, contact arrangement, keying, insert orientation and coupling design.
- Match the contact count and exact insert arrangement.
- Confirm coding or keying to prevent an incorrect interface from mating.
- Verify the manufacturer’s specified mating connector part number.
- Check whether contacts are included or must be selected separately.
Select Coupling, Mounting and Termination
| Decision |
Common Options |
What It Controls |
| Coupling |
Threaded, bayonet, push-pull or latch |
Installation time, retention, vibration resistance and access space |
| Mounting |
Cable, panel, flange, device or PCB mount |
Mechanical integration, cutout dimensions and cable routing |
| Termination |
Crimp, solder, screw, through-hole or SMT |
Wire range, tooling, assembly process and serviceability |
| Cable Entry |
Straight or right-angle |
Rear clearance, bend radius and strain at the cable exit |
For industrial metric interfaces, the M12 Connector Selection and Sourcing Guide explains coding, pinouts, locking, mounting and protection requirements in greater detail.
Complete the Cable-Side Assembly
Connector body → contacts and insert → backshell → cable clamp or strain relief → cable
Use Circular Connector Contacts when the selected shell requires separately ordered pins or sockets. Match the contact series, size, gender, wire gauge, termination and plating to the connector insert.
Add compatible Backshells & Cable Clamps when the assembly requires cable retention, strain relief, shielding support or protection at the connector’s rear interface. For separately supplied bodies or shells, browse Connector Housings.
Validate Protection as a Complete System
Check rated current and voltage, contact plating, operating temperature, mating cycles, vibration, shielding and the required degree of environmental protection. An IP rating may depend on correct mating, seal compression, cable diameter, backshell selection and installation method, so verify the complete assembly rather than the connector body alone.
Record the interface: series, plug MPN, receptacle MPN, shell size, contact arrangement, contact gender, coding, coupling, mounting, termination, backshell, cable range, electrical ratings and environmental protection.