Circular connector accessories complete the protection, sealing, mounting and maintenance of compatible connector assemblies. Browse dust caps, sealing plugs, flange gaskets, mounting nuts and related hardware by connector series, shell size, mounting position, material and environmental requirement. Confirm the manufacturer part series and interface dimensions before adding an accessory to the assembly.
Select Accessories by Assembly Function
Start with the connector that requires an accessory, then identify the unprotected or incomplete point in the assembly. The required part may protect an unmated interface, seal an unused opening, secure the connector to a panel or retain another component. Match every accessory to the manufacturer series and connector dimensions before checking environmental performance.
| Function |
Typical Accessories |
Selection Focus |
| Protect |
Dust caps and protective covers |
Interface type, shell size and attachment method |
| Seal |
Sealing plugs, flange gaskets and O-rings |
Seal location, dimensions, material and temperature |
| Mount |
Mounting nuts, washers and panel hardware |
Thread, panel opening and mounting side |
| Retain |
Clips, rings and locking hardware |
Series compatibility and retention position |
Match the Accessory to the Connector
Use the manufacturer name and part series of the existing circular connector as the starting reference. Confirm the shell size, plug or receptacle interface, coupling thread, flange dimensions and intended mounting position. A similar-looking cap, gasket or nut may use different threads, sealing surfaces or retention features.
Connector Details
- Manufacturer and product series
- Shell or interface size
- Plug or receptacle side
- Thread and coupling dimensions
- Front-mount or rear-mount installation
Accessory Details
- Accessory type and installation point
- Material and finish
- Seal or gasket dimensions
- Attachment and retention method
- Operating temperature and environment
Complete the Sealing Path
Identify where environmental protection is required. A dust cap protects an unmated connector interface, while a sealing plug closes an unused cavity or opening. A flange gasket seals the joint between a panel-mounted connector and the equipment enclosure. At the cable entry, compatible backshells and cable clamps can provide cable retention, strain relief and additional environmental protection.
Verify the material against the expected temperature, moisture, chemicals, sunlight and mechanical exposure. The final IP rating depends on the complete assembly, including the connector, accessory, seals, mating component and correct installation. Use the published rating for the assembled configuration rather than treating one accessory as an independent guarantee.
Circular Connector Accessory Checklist
- Record the connector manufacturer, series and part number.
- Identify whether the accessory must protect, seal, mount or retain.
- Confirm the shell size, thread, interface and installation side.
- Compare material, finish and operating-temperature requirements.
- Check the required gasket, seal and attachment hardware.
- Verify fit, retention and environmental protection after installation.
For M12 assemblies, use the M12 connector selection guide to confirm the connector format, mounting arrangement and environmental requirements. Record each accessory as a separate BOM item with its compatible connector part number to simplify assembly review and replacement sourcing.