Rectangular connector contacts include separately ordered pins, sockets and crimp terminals for compatible connector housings. Begin with the manufacturer series and housing part number, then match the cavity, contact gender, wire range, termination, plating and application tooling. Similar appearance or wire size alone does not establish compatibility.
Lock the Housing Series Before Selecting a Contact
The housing determines which contact family and retention geometry can be used. Follow the approved compatibility path instead of selecting a terminal from its shape alone.
Manufacturer series → Housing part number → Cavity and contact size → Pin or socket → Approved contact
Use the housing datasheet or application specification to find the compatible contact part number. The same connector series may use different contacts for conductor size, insulation diameter, plating, sealing or production packaging. If the housing has not been selected, start with Rectangular Connector Housings.
Match Both Ends of the Contact
Each contact must fit the mating interface, lock into the correct housing cavity and accept the intended wire. Record all three interfaces before comparing stock or pricing.
| Contact section |
What must match |
Fields to verify |
| Mating end |
The opposite conductive contact |
Pin, socket or non-gendered type; contact size and finish |
| Housing interface |
The cavity and retention system |
Series, cavity size, locking lance and insertion direction |
| Wire end |
The conductor and insulation |
AWG or cross-sectional area, conductor type and insulation diameter |
| Termination area |
The specified assembly process |
Crimp, solder, press-fit or other manufacturer-approved method |
For a complete PCB header, wire housing and terminal combination, compare the available Wire to Board Connectors and verify every component against the same product series.
Choose the Contact Construction and Packaging
| Contact form |
Selection focus |
| Stamped and formed |
Wire and insulation range, open-barrel geometry, reel format and specified crimp die |
| Machined or solid |
Contact size, conductor range, electrical load and dedicated tooling |
| Loose-piece packaging |
Prototype, service or manual assembly requirements |
| Reel or strip packaging |
Applicator compatibility, feed direction, carrier pitch and production quantity |
Match the Wire, Finish and Electrical Load
- Confirm the complete conductor range in AWG or square millimetres.
- Check conductor stranding and the permitted insulation outside diameter.
- Compare contact material, tin or gold finish, and any specified plating thickness.
- Verify current rating under the stated wire, contact and temperature conditions.
- Check operating temperature, mating durability, vibration and environmental exposure.
Contact finish should be evaluated as part of the complete mating pair. Confirm that both sides use finishes approved by the connector manufacturer for the required environment and mating life.
Include Tooling in the Contact Selection
For crimp contacts, identify the manufacturer-specified hand tool or applicator, locator, die set, strip length and crimp-height requirements. Production inspection may also include conductor position, insulation support, bellmouth, pull force and contact deformation.
After termination, insert the contact in the specified direction until its retention feature locks into the housing. Use the approved extraction tool when removal is required. The guide to connector pins, crimping, soldering and IDC provides additional guidance on termination methods and crimp inspection.
Create a Contact Procurement Record
Record the housing series and part number, contact part number, pin or socket type, wire range, insulation diameter, termination, plating, packaging and required tooling. This provides a more reliable basis for replacement and production sourcing than appearance or wire size alone.
If the required interface or connector family has not yet been determined, return to the broader Rectangular Connectors range before selecting individual contacts.