Parallel port D-Sub connectors provide multi-contact interfaces for legacy peripherals, SCSI-style equipment and industrial parallel data connections. Begin with the equipment interface and required pin map, then match contact count, pitch, plug or receptacle, mounting orientation, termination and locking hardware. Confirm the manufacturer series and mating part before selecting a replacement.
Define the Parallel Interface
Start with the equipment specification or original connector part number. Parallel-port connectors can be used in legacy peripheral, SCSI-style and industrial systems, but their signal assignments are not defined by shape alone. Record the application, contact count, pitch, contact arrangement and pin map before comparing mechanical options.
| Interface Detail |
What to Confirm |
| Application |
Peripheral, SCSI-style or industrial parallel interface |
| Contact Layout |
Contact count, rows, pitch and exact arrangement |
| Connector Role |
Plug, receptacle and mating contact interface |
| Pin Map |
Signal, ground, shield and reserved positions |
| Mating Series |
Manufacturer series and specified mating part number |
Verify Three Levels of Compatibility
Mechanical Fit
Match the connector body, contact layout, pitch, plug or receptacle role, polarization and retention hardware.
Electrical Pin Map
Confirm that signal, ground and shield positions on both sides follow the same equipment wiring specification.
System Interface
Verify that the connector and cable assembly support the required parallel communication or equipment interface.
Valid replacement: Mechanical fit + Electrical pin map + System interface
Browse D-Sub connectors when the application uses a standard D-Sub interface rather than a high-contact-count parallel or SCSI-style format.
Choose Mounting, Orientation and Termination
Select a board, panel, cable or edge-mount connector according to the equipment design. PCB products may use vertical or right-angle orientation, through-hole or surface-mount termination and board locks for mechanical support. Cable-mounted versions may use wire or ribbon-cable termination and require space for a hood, latch or strain-relief assembly.
- PCB fit: Confirm board thickness, footprint, mounting-hole positions and orientation.
- Panel fit: Check the cutout, connector body dimensions and front or rear mounting position.
- Termination: Match through-hole, SMD, IDC or wire termination to the assembly process.
- Retention: Select board locks, threaded locks, latches or other specified hardware.
- Clearance: Allow space for mating, locking, cable routing and service access.
Complete the Cable and Hardware Assembly
Cable-side connectors may require compatible D-Sub backshells for cable protection, strain relief and shielding support. Match the backshell to the connector body size, cable diameter, cable exit direction and locking method. Use D-Sub accessories for compatible mounting and retention components.
Parallel Port Connector Replacement Checklist
- Record the original manufacturer and part number.
- Confirm the equipment interface and complete pin map.
- Match contact count, pitch, rows and connector role.
- Verify board, panel or cable mounting dimensions.
- Select the required orientation, termination and retention hardware.
- Check contact plating, electrical ratings and shielding requirements.
- Record the mating connector, backshell and accessories in the BOM.