FFC/FPC contacts are separate conductive terminals installed into compatible connector housings. Begin with the housing manufacturer, series and cavity specification, then match the contact gender, retention geometry, conductor range, termination method and required application tooling.
Anchor the Contact to Its Housing
Select the contact from the housing manufacturer’s approved component list or application specification. Similar-looking terminals with the same nominal pitch may use different locking lances, insertion depths or mating geometry. Browse FFC/FPC Housings when the compatible connector body must also be sourced.
Housing manufacturer + product series + cavity specification + approved contact part number
Use this relationship as the selection baseline before comparing plating, conductor range or packaging.
Read the Terminal from Front to Rear
Mating end Pin or socket interface
Retention section Housing locking lance
Conductor section Electrical termination
Rear support Insulation retention
Each section must suit the same assembly. Changing the contact at one end can alter housing retention, mating engagement or the permitted conductor construction.
Identify the Mating End
Determine whether the terminal is a pin or socket and confirm which mating contact it engages. Check contact orientation, engagement length and insertion direction against the connector drawing rather than identifying gender from the housing shape alone.
- Confirm the contact part number is approved for the selected housing cavity.
- Match pin and socket interfaces within the same connector family.
- Check that the retention lance faces the correct direction before insertion.
Size the Termination Section
Match the contact to the conductor construction and dimensions specified by the manufacturer. For crimp contacts, record the supported conductor range, insulation diameter, strip length and terminal material thickness. For solder or press-in variants, follow the applicable series drawing and assembly process.
Contact plating Check the mating-area finish and any different finish specified for the termination area.
Packaging format Confirm loose-piece, strip or reel packaging matches the intended production method.
Application tooling Use the specified hand tool, applicator, die set and insertion or extraction tool.
Preserve the Crimp Evidence
Inspect a terminated contact before it is inserted into the housing. Use the manufacturer’s crimp-height and pull-force requirements for the exact terminal and conductor combination.
Conductor strands are visible in the inspection area.
Bellmouth and conductor crimp are formed to specification.
Retention lance and mating surfaces remain undamaged.
Contact is fully seated and locked inside the correct housing cavity.