Female socket headers receive male pins to create removable PCB, module and board-to-board connections. Begin with the mating pin’s pitch, cross-section and contact arrangement, then define the acceptable insertion depth, socket height, entry direction and PCB termination needed for a mechanically secure and electrically stable connection.
Build the Mating Pair from the Male Pin
- Match the contact layout. Confirm pitch, number of positions, number of rows, row spacing and any intentionally unpopulated positions.
- Check the pin envelope. Compare the male pin’s width, thickness, shape and plating with the socket’s accepted contact range.
- Calculate contact engagement. The exposed male post must reach the female contact’s working area without exceeding its maximum insertion depth.
- Confirm polarization. Shrouds, keys, locating features and pin-one orientation must align across both halves.
Use Male Pin Headers to identify the corresponding exposed-pin connector before approving the female socket.
Check the Contact Engagement Window
Pitch compatibility does not confirm a complete match. The socket contact must grip the specified male pin and maintain enough overlap for the expected current, signal and mechanical conditions.
| Drawing Field |
Required Comparison |
Mismatch Risk |
| Accepted pin size |
Male contact width, thickness and cross-section |
Loose contact or damaged spring beams |
| Minimum insertion depth |
Available male post length after accounting for body height |
Incomplete engagement or unstable resistance |
| Maximum insertion depth |
Post length entering the socket cavity |
Bottoming out or permanent contact deformation |
| Contact finish |
Female and male mating-surface plating |
Accelerated wear or inconsistent contact performance |
Set the Installed Connection Height
Determine the finished assembly height from the female socket body, male header insulator, exposed post and actual mating overlap. For module sockets, confirm that the module seats at the intended height without contacting nearby components. For two-PCB assemblies, verify parallel-board spacing, component clearance and access for separation.
Height check: Female body height + exposed male structure − mating overlap = approximate installed connection height. Use the manufacturer drawings for the final tolerance calculation.
If controlled board spacing, elevated PCBs or pass-through contacts are the primary requirement, compare Board Stacking Connectors.
Select the Entry and PCB Side
| Top-entry |
Choose for perpendicular mating above the PCB; check overhead clearance and extraction space. |
| Side-entry |
Choose for board-edge access or low-profile assemblies; confirm lateral keepout space. |
| Through-hole |
Match the finished-hole pattern, board thickness and solder-tail length. |
| Surface-mount |
Verify the recommended land pattern, coplanarity, locating features and reflow limits. |
Unusual contact layouts, non-standard pin lengths or application-specific mating geometry may require Special Pin Headers. For additional guidance on header pitch, rows, mounting styles, pin dimensions and alternative-part evaluation, see the PCB Pin Header Selection Guide.
Record Both Halves in the BOM
Record the male and female part numbers together with pitch, positions, rows, accepted pin size, insertion-depth range, body height, installed height, entry direction, PCB mounting, plating and electrical ratings. Retaining both drawings and the approved mating combination helps prevent replacements that match the footprint but fail at the contact interface.