Contact connector components include plug-in test interfaces and fixed surface-mount contact pads. These parts provide access to electrical circuits or form the stationary mating surface for a moving contact.
Test interfaces within an electrical system
Test plugs, test terminal blocks and terminal strips form the connection points of a plug-in test system. They provide access at the equipment wiring interface rather than acting as individual wire-crimp contacts. The matching plug and terminal arrangement establish the test connection.
Phoenix Contact FAME systems support measuring and testing in protection and control engineering. Their plug arrangement and switching behavior belong to the coordinated system. Replacement components must preserve the specified circuit connections and switching sequence; testing follows the equipment and system procedures.
A fixed surface for a moving contact
A flat SMT contact pad provides a stationary mating surface for spring contacts or pogo pins. Harwin S70-220102045R is one such pad. The pad remains fixed on the PCB, while the opposing spring contact supplies the movement needed at the interface.
Pad geometry, surface finish and board placement define its physical relationship to the moving contact. The corresponding moving elements are described under Spring-Loaded Contacts. The two sides perform complementary but different mechanical roles.
Two different mating relationships
A test plug engages its matching terminal system, where contact arrangement and circuit behavior determine compatibility. A fixed pad meets a moving contact, where pad location and the contact tip determine the mating position. These two relationships call for different components even though both provide electrical contact.