Circular Connector Contacts

Results:

Circular connector contacts form the removable electrical interface inside compatible connector housings. Start with the connector series and cavity specification, then match pin or socket gender, contact size, conductor range and termination method. Confirm material, plating, electrical ratings, tooling and retention requirements before selecting a contact for assembly.

How to Select Circular Connector Contacts

A circular connector contact must fit at both ends: the housing interface must match the connector series and cavity, while the termination end must match the wire or cable. Begin with the part number or technical drawing of the existing connector housing. Verify its contact cavity size, supported contact type and retention system before comparing electrical specifications.

Housing Interface

  • Connector family and series
  • Contact and cavity size
  • Pin or socket contact
  • Insertion and retention method
  • Required cavity seals or accessories

Conductor Interface

  • Wire range in AWG or mm²
  • Conductor and insulation dimensions
  • Crimp, solder or other termination
  • Compatible cable type
  • Crimping and assembly tooling

Pin and Socket Contact Selection

Pin contacts use a projecting mating surface, while socket contacts receive the corresponding pin. Select contact gender from the connector insert arrangement and manufacturer documentation rather than relying only on whether the complete connector is described as a plug or receptacle. For additional terminology and mating guidance, refer to the plug and socket selection guide.

Match the Contact to Its Electrical Function

Signal contacts are generally selected for control, sensing and low-level communication circuits. Power contacts require suitable conductor capacity, contact size and current rating. Coaxial or RF contacts must also match the specified cable group, impedance and frequency requirements. These contact types may share a circular housing but are not automatically interchangeable.

Compare contact material, plating, contact resistance, current and voltage ratings, operating temperature and mating-cycle life. Gold plating is commonly considered for stable low-level signal performance, while silver-plated contacts may be used in suitable higher-current applications. The approved values must come from the individual product specification.

Crimp and Solder Termination

For crimp contacts, confirm the accepted wire range, conductor construction, insulation diameter and specified crimp tool, die or positioner. For solder contacts, check the solder-cup capacity and assembly temperature requirements. Coaxial contacts require additional dimensional matching for the center conductor, dielectric and shield. Use the manufacturer-approved preparation and termination procedure for consistent mechanical and electrical performance.

Contact Installation Checklist

  1. Verify the connector series, cavity position and contact size.
  2. Prepare the wire or cable to the specified strip dimensions.
  3. Crimp or solder the contact with the approved process and tooling.
  4. Inspect the termination for alignment, damage and exposed conductor.
  5. Insert the contact into the correct cavity until the retention feature engages.
  6. Perform the specified retention, continuity and mating checks.

Record the housing part number, cavity, contact size, contact gender, wire or cable, termination method, plating, rating and required tooling in the BOM. If the application requires a complete plug or receptacle rather than separate contacts, browse circular connectors and confirm that every component belongs to the same compatible connector system.

Read More
Circular Connector ContactsResults:
Comprehensive
Price Priority
Stock Priority
Image
Part Number
Description
Availability
Unit Price(USD)
Quantity
Operation
CIR CONTACT, PIN, CRIMP, 28-24AWG;
Available Stock
9,700
Estimated Ship Time:6-12 working days
10+$0.4159
100+$0.3726
2,500+$0.3593
5,000+$0.3593
- +
Ext. Price(USD):$24.95
MOQ:60
Mult:10
Available Stock
14,080
Estimated Ship Time:6-13 working days
10+$0.6831
25+$0.6107
5,000+$0.4244
10,000+$0.4028
- +
Ext. Price(USD):$14.34
MOQ:21
Mult:1
SPQ:1
25 / PageGoto