Backshells and cable clamps complete the rear side of a circular connector by supporting the cable, controlling its exit direction and reducing mechanical load on the terminations. Match the connector series, shell size and rear thread first, then verify cable diameter, clamp range, orientation, shielding, sealing and strain-relief requirements.
Follow the Rear-Side Load Path
Connector rear interface → backshell → cable clamp → strain relief → cable jacket
Start with the exact connector rather than the cable alone. Record the manufacturer, series, connector part number, shell size and rear accessory thread. The backshell must attach securely without interfering with the insert, contacts or coupling mechanism. Browse Circular Connectors when the mating connector or product series has not yet been selected.
Apply the Three-Fit Test
| Fit Test |
Parameters to Match |
What It Prevents |
| Connector fit |
Series, shell size, rear thread and compatible connector MPN |
Incorrect thread engagement or interference with the connector body |
| Cable fit |
Cable opening, bundle diameter and clamp range |
Loose retention, jacket damage or excessive compression |
| Installation fit |
Straight, 45° or 90° exit, rear clearance and bend radius |
Cable interference, sharp bending or an overstressed termination |
Select the Rear Accessory by Function
- Cable clamp or strain relief
- Secures the cable jacket or wire bundle so pulling, twisting and repeated bending are not transferred directly to crimped or soldered contacts.
- Backshell or end bell
- Encloses the connector rear and provides an interface for cable support, shielding hardware, seals or protective conduit.
- Backshell extender
- Adds internal space when conductor routing, contact termination or shielding components require more rear clearance.
- Shield termination backshell
- Provides a controlled mechanical interface for terminating cable braid or shield hardware to a conductive connector assembly.
- Environmental or potting shell
- Supports sealing, boot attachment or potting around the cable entry when specified by the connector system.
Keep Protection Functions Separate
Mechanical strain relief: controls cable pull, torsion and bending at the termination.
Environmental sealing: limits the entry of moisture, dust or contaminants at the cable interface.
EMI/RFI shielding: maintains a conductive path between the cable shield, backshell and equipment enclosure.
A cable clamp does not automatically provide sealing or shielding. Verify each function in the specific product drawing and assembly instructions. Material, plating, clamp hardware, seal construction and cable preparation all affect the installed result.
Confirm the Installed Cable Route
- Confirm that the clamp grips the cable jacket or supported bundle at the specified location.
- Check that the cable diameter falls within the accessory’s clamping or sealing range.
- Maintain the cable’s minimum bend radius after a straight or angled exit.
- Verify that assembly loads bypass the contacts and conductor terminations.
- Follow the manufacturer’s shield termination, seal compression and tightening instructions.
If the required item is a separately supplied connector body rather than a rear accessory, compare Connector Housings.
Record the Accessory Match
Connector MPN → series → shell size → rear thread → backshell or clamp MPN → cable opening → cable diameter → exit angle → material and plating → strain relief → shield termination → sealing → installation clearance